Not by default. There's a few pins exposed on the bottom of the device you could connect to and you could mount your own additional casing around perhaps.
Has a nice picture of the underneath of the module to give you an idea.
i Don't have that exact software version anymore and you couldn't do much with it because it communicates via CAN-bus with some other devices you probably don't have.
the sending to pybytes parts looks a lot like the provided example.
the time it crashed i didn't update a part i only tried to open the flash tab in pybytes.
i get the
Error publish [Errno 12] ENOMEM
more if i increase the wait time between some data bursts. with 60 seconds almost never but with 600 seconds more often.
this table is only for saving wifi credentials in Pybytes.
These wifi credentials could be selected (from the combo box) when you create a new device profile in Pybytes.
At this moment a device profile is "locked" with one wifi credentials which were selected during that particular device profile creation.
After that only when you update your Pycom device with the firmware updater, a Pycom device will receive new wifi credentials from Pybytes.
stacked option could create a stacked bar chart if you send an array of a tupple of values with your signal. But at this moment we don't support it, so it does nothing. We're going to refactor this part of UI.
We're going to update docs this week.