Connecting GPS antenna and a DHT22 to my expansion board2.0/LoPy?



  • Hello,

    I'm in a project where I have to communicate data like position, temperature and humidity trough TTN. So I connected a DHT22 to the expansion Board using a breadboard
    I was asking myself can I connect the gps antenna to the same breadboard and use the 3.3V pin to power the two modules (GPS antenna and DHT22)? without breaking or damaging them.
    I also though about putting the DHT22 on a PyTrack/LoPy but their is no pin for additional module. Maybe someone know a way to do it?



  • @gmaitre The 3.3 V output can supply up to 1 A current, so supplying a DHT22 and GPS module should not be a problem.
    The PyTrack board has an additional connector on the bottom, with some GPIO pins exposed, for instance P10 (G17) and P11 (G22). These could be used to connect the DHT22.



Pycom on Twitter