No repl after upgrade to FW1.5.1.b1 with new FW updater tool (SOLVED)



  • Hello,

    I had a problem that the board wasn't accessible anymore via repl or visible via IP address after upgrade of the firmware. The LED was RED without blinking.

    I solved the issue by redoing the same firmware upgrade but now without the high speed.
    This worked. Perhaps interesting for others with the same issue.

    Best regards,

    Peter



  • Thank you for sharing. Btw, I've always uncheck High speed transfer option, because simply it never worked for me. ;)


Log in to reply
 

Pycom on Twitter