[SOLVED] Can't update the firmware

[OceaneHebert]

Hi everyone !

I received the SiPy yesterday (with the expansion board) and I try to update the firmware but it doesn't work....
And I have an old version of it... I have the v. 1.1.2.b1... I saw in the forum that there is a v. 1.6.10.b1 ! But I can't find it...!

In addition, when I try to update the firmware, it says that "Setup has finished installing Pycom Firmware" (and I don't have the Device ID and PAC), but in "Atom" when I asked for the "firmware version" It says '1.6.10.b1'...

Can someone help me please ?

Thank you in advance !

Océane

I used the SiPy
On Windows 10
With Atom v.1.18.0 and Pymakr 1.0.3
I follow the start guide : https://docs.pycom.io/chapter/gettingstarted/installation/pymakr.html

[OceaneHebert]

It works ! Thank you !

[robert-hh]

@OceaneHebert This may be an access rigth problem. Can you coonect to the SiPy with a terminal emulator like Screen or Picocom. If no, you need the proper access right to /dev/ttyUSB0. The easiest was is with;:

sudo adduser <you_user_id> dialout

You have to logout login again, to make that acitve. Alternatively, you could try to run the update as super-user with sudo.

[OceaneHebert]

Hi@jmarcelino

I retry on Linux and yes, I saw the correct serial port, but it doesn't work too...
Here is the interface of the updating tool : 0_1503558174807_Problem_firmware_update.pdf

I have correctly followed this step :

1. Disconnect your device from your computer
2. Connect a jumper cable or wire between G23 and GND
3. Reconnect the board via USB to your computer
4. Run the Firmware Upgrade tool --> Doesn't work

[jmarcelino]

@OceaneHebert
Can you see the correct serial port in the Pycom Firmware Update app?
If so can you post what is it showing as here (or post a screenshot of the app)

[OceaneHebert]

Hi @livius
Yes of course... But it doesn't work...
I try on Mac OS too, and it says :
"The upgrade failed, please check the connections and try the steps again.
This is the log of the upgrading process :
Connecting..........
Failure !"

I have changed the USB cable but nothing change...

[livius]

@OceaneHebert
Hi did you followed this?
https://docs.pycom.io/chapter/gettingstarted/installation/firmwaretool.html