Wipy3 does only boot after re-connecting 5V input
-
Hello,
I have the following setup:
- Wipy3 in Expansion Board 3
- Another board (Atmega 1284P @ 5V) with 5V power regulator.
- SPI with 5v/3.3V level shifter inbetween the two boards. (working perfectly if Wipy is powered from USB).
Now I want to power the Wipy with the 5V power from the second board. (If second bopard is powered, Wipy should also boot) If I connect the GNDs and 5V to VIN, the USB-LED of the expension board is glimming, but the Wipy is NOT booting.
Only if I then re-connect the 5V input pin, the RGB LED flashes and the Wipy does boot. After that everything works.
How can I achieve the Wipy booting when 5V power is provided initially?
Thx for your support,
Roman -
@romnan It looks like some interference of the expansion board. What happens if you drop the expansion board 3 and connect the WiPy directly?
-
@robert-hh I just connected power drectly. That works, now I have to do some soldering in order to check if it works together with the level-shifter. Thx so far!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login