Pysense charging current
-
Hi all,
Don't have the tools at hand to check directly, but I was wondering... What is the charging current provided by the Pysense LiPo battery charger?
The expansion board has a jumper to select 100 mA / 450 mA, but I don't think it's configurable on the Pysense, or is it?
I usually leave batteries to charge overnight so I never really paid attention, but I need to have a few charged quickly right now and wondering how long it will take ;-(
-
@martinnn said in Pysense charging current:
@peterb If you look at the PCB, from pin 2 (ISET) of the charger a trace goes directly to a 0402 resistor (which is connected to GND), measuring 1.2 kOhm. Looks pretty obvious to me. Probably difficult to see without microscope though.
Thanks!
I will find a mircroscope.
-
@peterb If you look at the PCB, from pin 2 (ISET) of the charger a trace goes directly to a 0402 resistor (which is connected to GND), measuring 1.2 kOhm. Looks pretty obvious to me. Probably difficult to see without microscope though.
-
@jmarcelino said in Pysense charging current:
Hi @jcaron
The charger on Pysense/Pytrack is not configurable - always set to 450mA450 mA is a bit much for a 300 mAh battery specified for max 1 C chargecurrent.
Which resistor to replace to get it to 300 mA?
i.e. according BQ 24040 spec relace a 1k2 resistor with a 1k8 resistor?
-
Hi @jcaron
The charger on Pysense/Pytrack is not configurable - always set to 450mA
