Compile firmware for wipy2.0 success, but after reboot is red light
-
Hi, i
ve tried to compile the firmware from scratch and to flash my wipy2.0. Ive followed the instruction from the github https://github.com/pycom/pycom-micropython-sigfox and all went fine.
I`ve successfully flashed the firmware, to the point when the board reboots. Then i unplug the wire between gnd and g23, and reboot the board, but instead of the blue blinking led now there is a full red. Only way is to reflash with the flasher tool.
any help is appreciated, thanks -
@pedro You have to erase the flash before and then reload. There is an inconsistency between the pre-built images and the self-built ones. Erase the flash with:
make erase
and the reload with
make flash
You have to push reset before each make command, and the gnd/g23 wire has to be in place. Unfortuantely, the content of the local file system will be wiped out too. -
@robert-Thank you, worked perfectly
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login