Using Non-Standard LoRaWAN Frequencies

[kiwi64ajs]

Hi Guys,
First post to this forum...

I'm needing to be able to define a set of custom frequencies in the 868MHz range for LoRaWAN communications to a local commercial gateway that I cannot control...

Looking at the documentation here: https://docs.pycom.io/lopy/library/network.html#class-lora it says:

In LoRa.LORAWAN mode, only adr, public and tx_retries are used. All the other params will be ignored as theiy are handled by the LoRaWAN stack directly.

So as things are currently I'm picking that I cannot change the LoRaWAN frequencies this library is using. Is that correct or are the docs wrong?

Here is the table of frequencies I need to configure from here: http://kotahi.net/connect/

Channel Frequency (MHz) Bandwidth (kHz) Sp Factor/Data Rate
0 865.0 125 12-7/0-5
1 865.2 125 12-7/0-5
2 865.4 125 12-7/0-5
3 866.2 125 12-7/0-5
4 866.4 125 12-7/0-5
5 866.6 125 12-7/0-5
6 866.8 125 12-7/0-5
7 867.0 125 12-7/0-5
8 865.6 250 7/6

Any suggestions?

Regards
Alex Shepherd

[kiwi64ajs]

@mossynz said in Using Non-Standard LoRaWAN Frequencies:

Hi Alex, good to chat to you, as discussed Daniel and team should have the documentation updated about using the new API in this new firmware release. Cheers good luck - Mossy

@mossynz can you email your contact details to: kiwi64ajs at gmail.com

Regards

Alex Shepherd

[KDHeard]

@mossynz Thanks for the feedback. Do you know when the document will be available?

[mossynz]

Hi Alex, good to chat to you, as discussed Daniel and team should have the documentation updated about using the new API in this new firmware release. Cheers good luck - Mossy