Lopy 1.0 firmware update



  • Dear Community,

    I'm happy to have 1 LoPY 1.0 but cannot use it. (I'm a newbie so I'm learning..I bought it on kickstarter without knowing what to do with it but I like to lear new things.

    I count on you guys to help me out a bit.

    For now, I would like to make the firmware update but I have to connect a jumper cable...I don't have this cable...

    Normally Pycom send this cable with the lopy and the board right ?

    Unfortunately I don't have one and don't know what to do..

    let me know have your output.

    thanks a lot in advance.

    best regards from Switzerland.

    Cheers,
    Maka



  • @Makabeez Hey there Maka - the 'cable' is in fact just a wire that is used to connect the GND to G23. Any thin wire will do.

    Regards
    Kevin


Log in to reply
 

Looks like your connection to Pycom Forum was lost, please wait while we try to reconnect.