LOPY on a lorawan public network,

[chumelnicu]

@livius how can help that in to one lorawan public network?

I think was about how to set radio to SF12 in lorawan mode...

[danielm]

Use datarate DR0:

lora_sock.setsockopt(socket.SOL_LORA, socket.SO_DR, 0)

I believe it does not apply for OTAA join, for which specific datarate sequence is pre-defined.

[livius]

@chumelnicu
Sorry, too fast reading..

[chumelnicu]

@livius .. no problem ! :)

[lj]

@danielm

I tested your proposal (Using datarate DR0) :

• effectively I don't know if this has an effect for the OTAA JOINT, but at least data are sent using SF12.
  Thanks for the advice .

[danielm]

@lj
You are welcome. I believe that join attempts are sent with following sequence:
7x DR5, DR4, 7x DR5, DR3, 7x DR5, DR2, 7x DR5, DR1, 7x DR5, DR0
That means that in bad transmission conditions it may take several retries to achieve successful join.

[brunoS]

Hello,

with something like

while lora.has_joined() is not True
  try
     lora.join(activation=LoRa.OTAA, auth=(app_eui, app_key), timeout=20000, dr=0)
     ....

Join is always at SF12, I verifed with spectral analyser

[lj]

@brunoS
Hello , I added dr=0 as a param of my lora.join..command , seems to works ..but setting the timeout=20000, leads to timeout error in my case, so I left it to 0 as i am using the code exemple provided in the pycom documentation.
best

[brunoS]

@lj
You can " try catch" for intercept timeout exception and repet the JOIN to force DR=0.
With no timeout, join procedure use variable DR

[lj]

Hello bruno,

this is what I did, instead of using the exemple code, I can set and catch the timeout error hence loop while not joint.

while lora.has_joined() is not True:
try:
lora.join(activation=LoRa.OTAA, auth=(dev_eui, app_eui, app_key), timeout=20000, dr=0)
except Exception as e:
print('Not joined yet...')