LoPy Pin Out
joe2612 last edited by
LoPy Pin Out by pighixxx. Reposting this as a sticky.
thefebruaryman last edited by thefebruaryman
Ok I got it. One of the class Pin methods is exp_board method. So inputting
into the REPL will output
Pin('P9', mode=Pin.OUT, pull=None, drive=Pin.MED_POWER, alt=-1)
Meaning G16 on the expansion board is P9 on the chip.
thefebruaryman last edited by
I too would like to know how the physical pins on the lopy relate to the G inputs on the expansion board. Has any one made a look up table?
matamune last edited by
Thank you for this!
One question though, any pinouts file to match the board pins to the expansion board pins (ie: Pin XX <-> GXX)?
As I understand from the expansion board pinouts file, it is sequential (ie: G2 <-> P0, G1 <-> P1, ..., G10 <-> P23), am I correct?
Could we use directly the expansion board notation (GXX)?
Again, thank you for the amazing done her :)