Why MicroWebSrv not runnning on Wipy3.0 ?

[GDA45-78]

Hello everyboby, i need some help,

I m using Wipy3.0 with the last firmware (1.18). I downloaded MicroWebSrv from https://github.com/jczic/MicroWebSrv

I copied "main.py" to "start.py" and I m using this code in my Main.py :

from network import WLAN

# configure the WLAN subsystem in station mode (the default is AP)
wlan = WLAN(mode=WLAN.STA)
# go for fixed IP settings (IP, Subnet, Gateway, DNS)
#wlan.ifconfig(config=('10.1.10.178', '255.255.255.0', '10.1.10.254', '10.1.10.178'))
wlan.scan()     # scan for available networks
wlan.connect(ssid='my_network', auth=(WLAN.WPA2, 'azerty123'))
while not wlan.isconnected():
    pass
print(wlan.ifconfig())

With console into VS Code, I m using the command

import start

Nothing happens. Nothing to navigator. The command seems blocked.
I am obliged to make a hard reset

Someboby to help me.
Thanks

[jczic]

Hello,
If you want, I propose a new powerful embedded Web Server for MicroPython (and CPython) that supports route handlers, modules like WebSockets or PyhtmlTemplate and a lot of simultaneous requests.

Mostly used on ESP32, Pycom WiPy, STM32 on Pyboard, ... Robust and efficient (thousands requests on CPython!)

GitHub - Open Source - MIT.

--> https://github.com/jczic/MicroWebSrv2 <--