Unable to boot when on breadboard (LoPy)
-
Hi guys,
So i am in the final stages of putting this device into a live environment where i need to control a pump.
My idea was to slim it down a bit by not using the expansion board (2.0).But when i connect 5v (tested with 3.5v aswell) power to my LoPy directly it doesn't boot all the way. It is however drawing about 105mA constantly. My diagram basically looks like this: https://docs.pycom.io/chapter/gettingstarted/connection/lopy.html#wifi
Am i doing something wrong in my setup?
Do i need to connect some pins to tell it to boot correctly?Thanks in advance!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login