Codes size 1.18.0 vs. 1.19.0
-
Why is the firmware 1.19.0 about 200k larger than the version 1.18.0? The FiPy and LoPy4 builds exceed the size of the partition.
-
Hmm, openthread library is one big blob; I didn't pay lots of attention at code-size, as it worked fine on Lopy4.
I've thought to optimise in a later release, some logging might still be enabled. -
@catalin The LoPy4 code is just a little bit too large, and so it fits, since there is a gap between the two image areas. But the Fipy code exceeds that, and loading always results in a flash checksum error on the next boot.
-
@robert-hh A further look revealed, that both the LOPY4 and FIPY image are below 1536k. Only if I add one of the IN865 or EU433 regions AND my favorite frozen scripts, the FIPY build exceed 1536k.
Still some slimming is advised, or more room in the partition table.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login