Run Fipy USB Powerbank
-
This post is deleted! -
@tfgm Not directly with the FiPy. You can use a chip like INA219 to monitor the current & voltage at the wire getting in to the device, and then you can determine the mAh that have been consumed, and in combinations with the voltage also the energy. The timing resolution is not very good, mostly limited by the time you allow your code to measure. So you will miss small spikes & drops.
For convenience, there are modules with that chip available.
There are Python drivers from Adafruit and one here, tested on ESP32 and ESP8266: https://github.com/chrisb2/pyb_ina219
Both should be close to Pycom's python. The gap, if at all, should be in the I2C section.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login