Pinout documentation for development modules
-
The Pinout for the development modules shows the UART0 RTS and CTS and pins P11 and P8. I'm wondering for what purpose. At the same time, the documentation of the expansion board 3 does not tell, which pins, if at all, arfe connected to the RTS/CTS signals of the USB/UART bridge on the expansion board.If these are still at P19/P20 like for expansion board 2, then at least the documentation for Fipy should mention to remove the RTS/CTS jumpers when used on the expansion board (2).
-
Thanks for pointing it out robert. ill get this clarified and the docs updated.
-
@Paul-Thornton What is the answer to his question though? I too am very confused by the documentation for the Fipy and expansion boards. There is conflicting or outdated information regarding the expansion board v2.0 and v3.0. Often I don't know which is being referred to, and worse, Pycom's channel resellers like Mouser, Digikey, etc. often mix them up.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login