How to REALLY solve the firmware update failures

[Xykon]

@AntonioValente said in How to REALLY solve the firmware update failures:

It is possible to do firmware update with a FTDI cable (3.3V)? - I'm using Windows 10.

Yes.

It is necessary to connect CTS and RTS?

No.

[Xykon]

It is possible to do firmware update with a FTDI cable (3.3V)? - I'm using Windows 10.

I need to modify this somewhat. Your FTDI cable alone might not provide enough current to power the LoPy at 3.3V.

If you have a module that has both 3.3V and 5V power output then you can power the LoPy with 5V at VIN. If it is a cable that has only VCC (at 3.3V) you might need an additional power supply.

[AntonioValente]

My cable have 5V of power supply ans 3.3V communications.
I can get serial communications (115200 baudrate) and get a prompt ">>" but I can't do a firmware update neither a wireless connection through my PC running W10.
Any ideia?

Thanks,
Valente

[Xykon]

Do you have a multimeter to check the current used by the LoPy? I can see the LoPy using up to 200mA during boot when powered through VIN at 5V.

It might be that even the 5V output of your particular cable does not provide enough current for the LoPy.

[AntonioValente]

I have connected through an Arduino board and I can connect -
by wireless (I have to place a fixed IP address - solved);
and by COM port.
Also, I can run Python in Pymakr with the two modes (Wi-Fi and COM) - a simple test program to change RGB LED color.
The only thing I can't do is firmware upgrade. Since I have a new LoPy device I don't know if it is necessary to do a firmware upgrade.

Thanks,
Valente

[abilio]

Hi @AntonioValente, you definitely need to upgrade your firmware in order to properly select your country LoRa frequency, patch several important bugs and get new features. If you haven't, please check here. There you will find the official upgrade tools for upgrading the boards.

If you have any issue with it, feel free to start a new thread.

[Xykon]

@AntonioValente said in How to REALLY solve the firmware update failures:

The only thing I can't do is firmware upgrade.

Did you connect P2 to GND and reset the module before attempting the firmware upgrade?

[AntonioValente]

No. My mistake!
I just have done the firmware upgrade and everything works fine.
Thanks!

I will need to work with the I2C module. Where I can find LoPy pinout and I2C library documentation?

Thanks again,
Valente

[Xykon]

@AntonioValente said in How to REALLY solve the firmware update failures:

I will need to work with the I2C module. Where I can find LoPy pinout and I2C library documentation?

See here and further down:

P9 - SDA Bus 0
P10- SCL Bus 0

I'm currently testing a 24LC64 eeprom and no external pullup resistors are needed.

[abilio]

NOTE: this is an old thread with outdated information. Please use the official upgrade tool instead:
https://docs.pycom.io/pycom_esp32/pycom_esp32/firmware.html