Pycom Console not interactive on latest VSC/Pymakr
-
Still having difficulties in connecting and interacting with Pycom boards (1x FiPy, 2x LoPy on both Exp. board 2 and Pytrak). I can use a terminal (PuTTY/minicom) to access the REPL but inside Pycom Console (both Win10/64 and Ubuntu 18.10/64) I can't enter input mode, just output (seems to be read-only). Board version is 1.18.1.r1, VSC is 1.27.2 (node.js 8.9.3, embedded I think because installed version should be 10.10.0) and Pymakr is 1.0.3 (no other extension installed). Some commands work while other not. I can connect (serial) and see (just) the REPL output, run a script but not disconnect or enter e.g. ctrl/c to stop a running program. I also tried previous versions of VSC, still no success... Any idea? Thanks!
-
@luca-gamma Hi, we're looking into your problem. In the meantime, have you tried using Atom?
-
Hi @dan thanks for your reply. Actually not, also tried with an older VSC version (i.e. 1.25.1) but result is even worst (error: command pymakr.* not found and console doesn't start). Also downgraded Node.js to the LTS (8.12.0) but no luck. Because I'm using VSC for Python and to manage other non-pycom micropython-based boards via terminal it would be comfortable having a single IDE. Is there a particular setup known to work (firmware, VSC, Pymakr, Node.js, versions, platforms and architecture)?
PS: Using Atom 1.31.1 on Win10/64 with Pymakr 1.4.4 I notice no issues, REPL responds correctly.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login