I cant upload code to Fipy and Gpy

[stephen.ugwuanyi]

Fipy and Gpy previously working very well on NB-IoT network. Recently, I can't upload new codes and unable to fix this error. Machine reset and the reset button couldn't fix this. Any idea, please

with Fipy and Gpy.

Upload done, resetting board...
OKets Jun 8 2016 00:22:57

rst:0x7 (TG0WDT_SYS_RESET),boot:0x17 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:1
load:0x3fff9028,len:8
load:0x3fff9030,len:1060
load:0x4009fa00,len:0

[stephen.ugwuanyi]

@railmonitor Thanks for your response. I go them working again after updating the modules again with the latest firmware

[railmonitor]

Is this the only thing visible in console after uploading?

I always see something similar when uploading, so that is normal, but your code should naturally start running after what you posted appears in console. Have you tried just uploading a simple program that prints to console or turns on the LED?