Lopy continues to restart and then stops !!!
james last edited by james
I connected the L01 module equal to Lopy with a base later sent by pycom ..
their development base because I had a problem with lora then discovered it was a bug firmware.
A usb ftdi module is attached to the base.
in fact I do not know if unlike the LoPy no OEM lacks pullup qulche that can cause this ..
in real life until long ago I did not have problems ... everything worked pretty regularly ...
I attach you a photo:
the two jumper are related to the safeboot and the upgrades,
then I mounted a reset key that is in reality and is already on the module
I also have some mounted only with the necessary pins without any base but the same
(only power, antennas, and serial)
I also compiled everything from sources but the result is the same
excuse for my easy english...
@james As far as I know, the difference between L01 and LoPy is the form factor and whether antenna and power regulator are on board. L01:
The frequency mode 868 or 915 us defined by the firmware image you load. The question I have is: How do you interface to you L01. Do you have a kind of adapter or
I've updated the latest version ...
it stays silent
I downloaded the last and tried but nothing,
I am preparing the development environment now, so far I did not need it for what I'm doing.
But where do I find the firmware for the LY01 version of lopy ??
So far i just launched the update, and downgrade I unsure the versions for lopy 868 but not l01, maybe the problem might be this.
@james I assumed you used the pycom upgrader from here:
In that case, delete the one already on your computer and reinstall it.
If you used the developement environment, just update from github and redo a
make flash. And be sure to use a LoPy image for the L01 module.
B.t.w: There is a new firmware version out there.
@robert-hh in what way to update the loader ???
@james Try to upgrade the loader first, and then the firmware again. There was some forth & back from 1.7.9b1 to 1.7.9b3 with the flash frequency.
The LoPy_868-1.7.9.b1.tar.gz version is part and remains of:
The LoPy_868-1.7.9.b1.tar.gz as the last one, keep restarting.
I tried with version 1.6.0.b1 and everything seems to be ok.
I got one in the forum just to try.
I attach you an image
@james That's bad. So it is rebooting again over & over?
Can you go back to a previous firmware version?
After the flash is deleted, the result does not change.
python3 esptool.py -p /dev/ttyUSB0 -b 115200 --chip esp32 erase_flash
If you have the build environment installed, just call