SIM slot and G01 on custom board
-
I just soldered first prototype of my custom board equipped with G01 (factory LTE firmware) and nano SIM slot. Sending "AT+CPIN?" via LTE.send_at_command() returns status "READY". Does it mean that interconnection between SIM and G01 is performing as expected or should I try some different command to verify hardware design? My area is not yet covered by LTE-M or NB-IoT so I cannot test connectivity directly. To do so I must travel to different part of my country, however prior to that I would like to verify hardware functionality.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login