Safe boot not working
-
I've followed the steps from the docs on how to enter safe boot https://docs.pycom.io/chapter/gettingstarted/programming/safeboot.html and was able to get this working the first time I did this, but I'm having some difficulty this time around.
I have the latest versions of the firmware (1.17.3.b1), Atom (1.25.1), and Pymakr (1.2.12) and my LoPy is attached to the expansion board correctly (reset button on the same side as USB connector). Pins are also looking firmly in place.
And yet when I connect P12 to 3V3 and press reset, the LED flashes blue like it normally would rather than orange.
Am I completely overlooking something or is my board just screwed?
-
that sounds like the correct procedure, have you tried a jumper cable?
-
@obladio instead of pulling P12 up, you could also try to enter Ctrl-F at the REPL prompt. That should also perform a safe boot.
-
@robert-hh This worked, thank you!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login