Keep getting 'Not Attached' with LTE-M in Netherlands on KPN network.

[mronday]

@jmarcelino

Ahh, that explains a lot :)

Where can I keep updated about the support for KPN?

[jmarcelino]

@mronday

Yes sorry about that.
All Announcements (Firmware, Network updates, etc) come in the Announcements part of the forum:

https://forum.pycom.io/category/1/announcements-news

Thanks

[mronday]

@jmarcelino said in Keep getting 'Not Attached' with LTE-M in Netherlands on KPN network.:

https://forum.pycom.io/category/1/announcements-news

Thanks :)

[pmb_nl]

@mronday Any progress? I also have FIPYs that I want to connect to the KPN LTE-M network.
Perhaps also good to ask help in the KPN LTE-M Forum . This is a forum in startup mode but questions will be read by the KPN IoT team and hopefully with good solutions.

Best regards,

Peter

[Xykon]

From what we're told you'll need a special SIM card from KPN but we're still waiting for more details.

We were supposed to meet with KPN today but unfortunately this has been postponed. We're hoping to receive more information next week.

[pmb_nl]

@xykon They have the process in place to supply SIM cards for the LTE-M network. I also used it to connect via a Sodaq board with uBlox but are also eager to testdrive with my two FIPY boards. I understood from this forum that there is work to be done from the firmware side. Any clarification would be welcome.

[Xykon]

@pmb_nl I am not working directly on the LTE side of things, I was just relaying a message from the team. I will post more information once they are available.

[flo242]

To get pycom to attach to KPN we needed to use the following AT-Commands before lte.attach()

lte.send_at_cmd('AT+CFUN=0') # disable modem
lte.send_at_cmd('AT!="clearscanconfig"') # clear scanned frequencies
lte.send_at_cmd('AT!="addscanfreq band=20 dl-earfcn=6400"') # set scanned frequency
lte.send_at_cmd('AT+CFUN=1') # enable modem

Maybe this helps. It worked for us but we ran into other difficulties later (at some point the Modem doesn't seem to receive any more UDP packets from our server, but sending still works)..

[mronday]

@flo242

Thanks will try next week !

[pmb_nl]

@flo242 FiPy works without problems on the KPN NL network?

[flo242]

@pmb_nl Yes it works without any problems the last few weeks so far