Pycom blinking faint blue light
-
After I try to connect the battery and the energy power together in the expansion board v3, my lopy4 does not start anymore.
The only thing it does after a reset is to blink the RGB led in a faint blue light, constantly.
Anyone knows what that means?
Is there any part of the documentation where I can found explanation about this behavior?Some additional information:
- The expansion board is dead, I cannot connect via serial.
- I can still upload a software through Wifi/FTP, but none of them run.
- When I try to start the board in safe mode, an orange light blinks, first slow, than fast, than it goes away and the blue blinks come back.
Thanks in advance for any information.
-
@dpalharini Can you connect and get a REPL prompt via Telnet? if ftp works, then Telnet should work too.
-
Hi @dpalharini
Does the board work when powered with USB? Try pulling
P8high, if you also want to use the SD card, use a 10k pull-up.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login