Sending AT Commands with Gpy

  • Hello, back for some more questions. So I'm trying to scan for LTE network in the area using some AT Commands. I tried using AT+SQNINS=<state> but I dont think I got all of the outputs. I tried the following below.

    >>> lte.send_at_cmd('AT+SQNINS=0')
    '\r\n+SQNINS: 0,4,7,,,,,,,,\r\n+SQNINS: 0,13,7,,,,,,,,\r\n\r\nOK\r\n'
    >>> lte.send_at_cmd('AT+SQNINS=1')
    '\r\n+SQNINS: 1,4,7,,,,,,,,\r\n+SQNINS: 1,13,7,,,,,,,,\r\n\r\nOK\r\n'

    how could I show the other outputs from the command like the cell id, pci, rsrp and rsrq?
    Do I need to upgrade firmware?

  • Did you manage to get anything with this command? im using NBIOT and getting :

    '\r\n+SQNINS: 0,4,7,,,,,,,,\r\n+SQNINS: 0,13,7,,,,,,,,\r\n\r\nOK\r\n'

    which is quite empty....

Log in to reply

Pycom on Twitter