New firmware release v1.12.0.b1 (Sigfox and LoRa coexistency on the FiPy)

[Xykon]

@danielm You can do that with the command line version of the tool. I will post some more details about that with the next beta release.

[naveen]

Why am I getting sigfox.id() and sigfox.pac() as b'ffffffff' and b'ffffffffffffffff' respectively?

[daniel]

@naveen did you get the Sigfox ID and PAC printed on the screen after the updater tool completed?

[naveen]

I am getting the message shown below but no id or pac info:

Result:
Your device was successfully updated!
Please remove the wire and reset the board.

[daniel]

After updating and doing:

import os
os.uname()

What do you get?

Cheers,
Daniel

[naveen]

Everytime I run "os.uname()", FiPy disconnects and only gives partial output as below:
(sysname='FiPy', nodename='FiPy', release='1.12.0.b1', version='v1.8.6-849-fcbbfe3 on 2018-01-03', machine='FiPy with ESP32' , lorawan=' > Failed to connect (Connection was reset)

[daniel]

@naveen please let us know your WLAN mac address so that we can reset and you can get your Sigfox ID and PAC again.

Please run:

import binascii
from network import WLAN

print(binascii.hexlify(WLAN().mac()))

And let us know your MAC address. Thanks.

Cheers,
Daniel

[naveen]

Mac address: <removed by admin>

[Xykon]

@naveen It seems your sigfox credentials haven't been properly generated during the initial upgrade/device registration.

I have removed your device... can you please try to upgrade/register again?

[naveen]

OK, I am trying to upgrade/register again. Now I see an option "Country Selection" and I choose "Japan" where I live. Next is "SigFox region selection" but I do not find "Japan" in the available options.

[daniel]

@naveen we will add Japan with the next release of the updater tool. In the meantime, please select Europe as Sigfox region. Thanks.

[livius]

@daniel
Wipy2
I give another try with recent software compared to 1.7.2.b1 {which is stablest for me for wipy2}.
After flash (today):

1. connection to router give me timeout (30seconds) but if i ignore this i can connect to the socket in the network - i use static ip setting.
2. i2c (i2c=I2C(0, I2C.MASTER, baudrate=100000, pins=("P9", "P10")))

• bh1750 ok,
• pcf8574 ok
• read from bmp180 read only 0 for preasure but temperature is ok

flashed 3 times and tested 30 times with removing cables (5 times and also simple reset 5 for every flash).

downgraded to 1.7.2.b1 all work ok.
I must bring back my logic analyser to see issue on i2c but maybe you have some hint here?
And also what can be the reason of issue from point 1?