Lopy P8 Pin is always HIGH
I'm a little bit frustrated about this.
p = Pin("P8", mode=Pin.OUT) p.value(0)
The pin is always high.
According the LoPy pinout this pin is not reserved...
What I miss?
I upgraded the board to 1.6.10.b1 and it is ok.
But there is another behavior still running. P19 is delivering only 2.65V on High... And I really need that pin....
jmarcelino last edited by
That was reported https://forum.pycom.io/topic/930/new-firmware-release-1-6-9-b1-frozen-code-support-and-framebuf/17 and fixed in the Github version https://github.com/pycom/pycom-micropython-sigfox/commit/195813d432d9f41314ef9923104b21db1282edf8