LoPy Firmware updates fail on Win10

[rskoniec]

Yes, COM3 shows up as 'USB Serial Device'. However, this does not disappear when I unplug the LoPy from USB

@jmarcelino What I understand is that @Jakko is fully aware that COM3 is not a LoPy. ;)

[jmarcelino]

Oh OK sorry, I was going by the second screen where he tried it..

Can you try another microUSB cable? I know you said it worked before but maybe it was another one. There are many "power only" cables out there which could explain these symptoms.

I dont think Pycom actually send USB cables, at least I never got one.

Also try connecting to a different port on your computer. Until it's detected as a device it won't really work.

[rskoniec]

@jmarcelino said in LoPy Firmware updates fail on Win10:

I dont think Pycom actually send USB cables, at least I never got one.

Neither do I.

[rskoniec]

@Jakko said in LoPy Firmware updates fail on Win10:

For comparison, I checked what happens when I plug and unplug an arduino. Then, "Arduino Uno (COM6)" pops up in device manager when I plug it in, and it immediately disappears when I unplug it.

I assume that for Arduino test you've used different USB cable as UNO have USB B type connector.

[Jakko]

@rskoniec and @jmarcelino,

Just now I tried updating with a different USB cable (of my phone, of which I was sure the data channels were connected), and a couple of things happened:

• A new device popped up in device manager
• The firmware update worked perfectly fine
• I thanked you guys silently for preventing me from wasting any more time.

So, solved! It amazes me how such a tiny mistake can cost so much time (in total, I spend a whole day on this).

Thanks!

[rskoniec]

@Jakko We're happy for your success. It's pretty regular that small mistakes sometimes make huge problems. ;o)

[rskoniec]

I've created a new topic https://forum.pycom.io/topic/763/firmware-upgrade-troubleshooting-checklist
I think it will be helpful for the others having similar issues.
I don't know if place in forum hierarchy is right - if not I hope Forum Admins will do the job. ;o)

[dClaus]

I have also the "Connecting ......... Failure !" problem with windows10 for the update of Lopy 1.4 to 1.6 !

The solution is :

• set the connection between G23 and GND,
• connect the LoPy expansion board to the computer with a USB cable
• !!! use the RESET buttom on the Lopy !!!
• use the firmware updater (1.1.1.b1)

It works for me on my 2 Lopy !

Damien

[rskoniec]

@dClaus said in LoPy Firmware updates fail on Win10:

!!! use the RESET buttom on the Lopy !!!

Thanx! I've added this to my topic.

[dClaus]

@dClaus said in LoPy Firmware updates fail on Win10:

I have also the "Connecting ......... Failure !" problem with windows10 for the update of Lopy 1.4 to 1.6 !

The solution is :

• set the connection between G23 and GND,
• connect the LoPy expansion board to the computer with a USB cable
• !!! use the RESET buttom on the Lopy !!!
• use the firmware updater (1.1.1.b1)

It works for me on my 2 Lopy !

Damien

"use the RESET buttom" is not necessary for the WiPy2

[rskoniec]

@dClaus said in LoPy Firmware updates fail on Win10:

"use the RESET buttom" is not necessary for the WiPy2

Thanx! Good to know. Topic updated!