@matamune you can turn automatic gc on gc.enable() and also you can do manual gc.collect()

@livius thx for your advice, there haven't been a second pysense.py but a lot of other crap and folders, i deleted them now it is working fine! Thank you! i will now use ftp to upload my libs or at least check if everything is ok

@jonasde On the bottom of your Pysense board you will find a 5x2 header you can solder to (see: https://docs.pycom.io/chapter/datasheets/downloads/pysense-pinout.pdf) When I connected it I used P8 and P4 which are availble on pins 9 and 10 of the external header. You will also need to connect to GND and 3V3_Sensor to the modules GND and Vdd pins.

@seb Yep! That fixed it. Thanks! Cheers, Thomas

Hi @JVGD, thanks for reporting this. Looking at the error message, I'm wondering if you can check if the folder '~/.atom/packages/pymakr' is in lower case, not uppercase as 'Pymakr'? There was a change from uppercase to lowercase a couple of versions ago, but in some cases the uppercase version stayed in some atom cache or config file, causing issues like this... If it's in uppercase, please try to un-install and install the latest version of Pymakr (1.2.7). Some more suggestions to solve the issue were discussed here: https://github.com/pycom/pymakr-atom/issues/53

Did you ever get it work? Any advise for me, as I am in the exact same situation?

@cduplouy I am also getting around 15mA during deepsleep. I tried with 3.3v and 3.7v using resistor but then it is not sufficient power for the pycom to run.

Thanks. Yes it was a power cable only. Working fine with other cable. Regards, Sameer

@livius i did already.. still the same problem.. Now i connected my lopy to raspberry pi through usb0 and putty.. the data bieng sent by raspberry pi is showing on the terminal instead of in uart.readall()...

@seb Thanks! Someone should fix this in doc. I'm running the latest stable firmware on wipy3, SPI device is hooked to default pins (as in pinout diagram) and it wasn't working until I've explicitly passed them in pins during SPI initialization. Most of the day yesterday I was struggling to make it work.

@robert-hh Thank you, that worked perfectly.

@livius Thank you so much!!! that's exactly what I needed

@jmarcelino Oh yes, I forgot the connect command of rshell. You can also edit through that tool, with edit filename

Thanks very much. From my experience, it is like if some flag is not reset when you press the reset button or you call machine.reset().

@seb https://docs.pycom.io/tutorials/introduction should be the link (without final / ) causing Newbie panic :)

I'm trying to use nano-gateway with loraserver.io but I can not downstream messages just upstream. Can you share if you had the same problem?